Skip to end of metadata
Go to start of metadata

By default, all components and filters selected for the population are used in the calculation of the population. If you are not sure which elements to include in the calculation, or if you temporarily want to exclude elements from the population in the chart, you can temporarily deactivate components and filters.

Steps:

  • Click the control located in front of the component or filter.

    If the current control is a check mark  (inclusive), click two times to put the component or filter into standby mode

    If the current control is a cross  (exclusive), click once to put the component or filter into standby mode. 

    The result of you action is immediately shown in the chart.


Clicking the  one more time will show the check mark again, and the component or filter is active again.


Population selection with deactivated component "Application data"